Stone Protec-S

ConfiAd® Stone Protec-S is a ready to use impregnation product for protection of heavy duty stain, based on modified alkylalkoxysilane. ConfiAd® Stone Protec-S is penetrated by the capillary forces of the stone. By the catalytic reaction, polysiloxan is formed, and react with silicate material of the stone resulting in effective and long-lasting effect for several years.

Stone Protec-water based


Technical Data Sheets


Polished surfaces: Approx. 15~30m2/L (161~322 ft2/qt.)
Porous surfaces: Approx. 8~15m2/L (86~161 ft2/qt.)
※Depending on porosity of surface.
12 tins of 1L (1.05 qt.), 12 tins of 4L (1.06 gal)
2 years approx. in original packing, if stored in a cool place free from frost.

 Characteristics & Properties


▶ Water repellent and protection against dirt, heavy duty
▶ Oil and grease repellent.
▶ Does not leave the surface film and maintain the
    breathing of the stone.
▶ Low adhesion of colors–anti graffiti effect.
▶ Ready to use: do not dilute.
▶ Weather resistant.
▶ Interior and exterior use.
▶ After being hardened the product is harmless to health
    upon contact with food products.


 Method of Use


1. Working in small areas (10 to 15m²) apply product
    generously and evenly until the surface appears wet.
2. On dense stones: keep wet between 5 and 15 minutes
    and ensure even distribution. Completely remove all
    excess – do not allow drying on the surface if not being
    absorbed into the stone.
3. On highly absorbent stones: keep wet between 5 to 15
    minutes and ensure even distribution. Immediately check
    the whole surface for an even finish.
4. Attention! The liquid product must soak into the stone. Do
    not allow the product to dry on the surface. Wipe excess
    product within 15 min.
5. If the product was not completely wiped off and a residue
    appears, wipe entire surface with a towel dampened with
    the product.
6. Glass, ceramics, wood, and other surfaces sensitive to
    solvents must be protected against splashes.
7. Application Temperature: the best conditions of
    impregnating are a temperature between 10°C and 25°C.
    The stone do not have to be warmed up under floor
    heating or direct sunlight.
8. Drying Time: the surface will be dry after 2 to 3 hours. Let
    it dry 24hrs before walking on the floor. Complete drying
    process and full effectiveness will take 1 week after.
    During this time, do not cover the surface and wipe up any
    spills immediately.




▶ Storage temperature: Between 5℃ (41℉) and 30℃
    Must be applied to material at temperature between 5℃
    (41℉) and 30℃ (86℉)


Field of Use


▶ Best protection for marble, granite, artificial stone,
    porcelain and tiles. It is also effective for terracotta and




Stone Protec

Stone Protec
Water based

Stone Protec
Lime stone

Stone Protec-S