How to use
How to use Tube Type
1. Open Component-B Tube.
Trim tip 1/4"(6mm) all non threaded part.
2. Inject Component-A into Component-B Tube.
Hold Component-B tube upright to avoid spills.
Slowly squeeze out around 2/3 air in Component-B tube.
Inject Component-A into Component-B tube by squeezing.
3. Close Component-B tube before mixing.
Close applicator cap tightly onto Component-B tube after squeeze out
around 2/3 air in Component-B tube.
4. Hold Component-B tube upright.
Mix thoroughly adhesive for around 5 minutes.
5. Trim Applicator cap starting just below the tip.
6. Discharge small amount from tube onto paper towel.
Immediately fill joint 1/3 to 1/2 full.
See ConfiAd Fabrication and Installation manual.
Number | Title | Writer | Inquiry | Date |
---|---|---|---|---|
6 | Safety Information | ConfiAd | 858 | 2016.03.23 19:45 |
5 | How to use Cartridge Type (250ml) | ConfiAd | 810 | 2016.03.23 19:44 |
4 | How to use Cartridge Type (50ml/75ml) | ConfiAd | 845 | 2016.03.23 19:44 |
>> | How to use Tube Type | ConfiAd | 834 | 2016.03.23 19:44 |
2 | Storage and Handling | ConfiAd | 834 | 2016.03.23 19:43 |
1 | ConfiAd Bulk Adhesives | ConfiAd | 853 | 2016.03.23 19:43 |